K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
2023-05-03 09:56:58
jiangxingTools
2720
K40,K42, K44 Carbide Standard Gear Hob with Topping or Non-Topping
Grade K40, K42, K44 carbide hobs are mostly used for large production, must be recoated after being resharpened.
Carbide gear hobs are offered with tooth profile DIN 3972 standard Non-Topping or Topping
module rangle for carbide hobs are M0.1-M5, OD Φ16-95, Length 8mm-180mm,bore Φ8-Φ40mm
carbide hobs for finishing cut, pre-grinding, pre-shaving, modified, chamfering, spline shaft, timing pulley, rectangular spline,triangular spline, worm/ratchet,etc special profile.
相關(guān)文章
-
Solid Carbide Hob
Solid Carbide HobProcessing step for tungsten carbide gear hob cutter as following:step o1-raw carbi... - PA20° Pre-shaving Gear Hob with Module m4
- RS100 Roller Chain Sprocket Hob with Pitch 31.75 x Roller Dia. 19.05
- PA20° Profile DIN3972 Standard Pre-grinding Gear Hobbing Cutter with Module m4.5
- PA20° Profile DIN3972 Standard Gear Hobbing Cutter with Module m7
- Features of Gear Cutting Hobs
- PA20° Profile DIN3972 Standard Pre-grinding Gear Cutter Hob with Module m3.75
