Taper Shank Type Shaper Cutters with DIN 1828
2023-03-26 14:07:45
jiangxingTools
2417
Taper Shank Type Shaper Cutters with DIN 1828
These shaper cutters are 20° PA, non-topping finishing cutters for straight spur gears,
tooth profile of shaper cutters is according to DIN 3972 profile Ⅱ，
there is no center hole on cutting face end of shaper cutter.
More taper is No. 2 and No.4 for above shank type shaper cutters.
相關(guān)文章
-
Hob Coating
Hob CoatingA hard coating with a thickness of 2-3um increase the life of the hobs, or permits higher... - Timing Pulley Hob for S.T.D XH(22.225)
- Single Thread Involute Gear Hob with DP
- Pre-grinding Rectangle Spline Hob
- RS50 Roller Chain Sprocket Hob with Pitch 15.875 x Roller Dia. 10.16
- HSS M42 Material for Gear Shaper Cutter and Gear Hob
- ?PA30° PCD 38mm Shank Type Gear Shaper Cutter with Module m1.75~m4
